Operating Instructions - Audiovox VME 9325 BTA Mode D'emploi

Parking Brake Inhibit
• When the "PRK SW" cable is connected to the brake switch, the display on the TFT monitor will display video only when the vehicle is applied.
• Parking brake function is overridden when the video source is set to CAMERA.
• When the parking brake inhibit is active, the front monitor displays "Parking Is On", preventing the driver from watching content while driving.
Rear video screens are not affected.
Mute
Press the MUTE button on remote control (3) to mute the volume from the unit. Press the MUTE button again to restore the volume. "MUTE" is dis-
played on the LCD. Adjusting the volume or using any of the audio setup features cancels the mute function. External peripheral devices can be
connected to this unit via RCA output or MediaLink. Select "AUX" mode to access and control connected auxiliary devices.

OPERATING INSTRUCTIONS

Power On / Off
Press the /SRC button (4) on the unit (or the
unit light up and the current mode status appears in the LCD (7).
Press and hold the button to power off the unit. The monitor is drawn back into the main compartment.
Audible Beep Confirmation
An audible beep tone confirms each function selection. The Beep tone can be disabled through the Setup menu.
Playing Source Selection
Press the SRC button (4) on the front panel or the SRC button (8) on the remote to change between available playing sources in the following order:
AM/FM/RDS, DISC, USB1, USB2, SD, AUX, CAMERA (Navigation can be selected if connected). The playing mode is displayed on the TFT and
LCD screens.
Volume Adjustment
To increase or decrease the volume level, turn the rotary encoder (7) on the front panel or press the VOL+/ VOL buttons (15, 16) on the remote con-
trol. When the volume level reaches "0" or "40", a beep sounds, indicating that the adjustment limit has been reached. The volume ranges from "0"
to "40". The LCD or TFT screen displays the volume level for 3 seconds.
Programmable Turn-On Volume
This feature allows the user to select a turn-on volume setting regardless of the volume setting prior to turning the unit
off. To program a specific turn-on volume level, turn the rotary encoder (7) to adjust the volume to the desired turn-on
volume. Push and hold the rotary encoder button while the yellow speaker icon and level indication is displayed on the screen.
The unit will beep two times to confirm your turn-on volume setting.
Audio Control Menu
The Audio Control feature allows you to easily adjust your audio system to meet the acoustical characteristics of your vehicle, which vary depen-
ding on the type of vehicle and its measurements. Proper setting of the Fader and Balance boosts the effects of the cabin equalizer. Press the AUDIO
button (5) on the front panel once to display the audio menu. To adjust an audio feature:
Function Adjustment option
EQ User
Rock
Hip Hop
Dance
Latin
Rave Urban Acoustic
FAD-BAL By push at the gridfield you can adjust the Fader/Balance accordingly.
/ POWER button (4) on the remote control) to turn the unit on. The buttons on the front of the
Adjustment of Bass/Mid/Treble seperately available
By push at the "EQ"-field you can choose between the pre adjusted EQ´s
14