Preparation; Using The Tool; Technical Data - J.C. SCHWARZ JTS 180 Mode D'emploi

Preparation

Adjust the speed level (MIN to 6) with the speed
dial 10. Choose the appropriate disk and speed
level depending on the operation purpose:
Sanding timber
Sanding disk, speed level 4-5
Smoothing filling material/plaster
Sanding disk, speed level 4-5
Removing wall paper
Sanding disk, brush disk, speed level 3-5
Removing plaster
Sanding disk, brush disk, speed level 4-5
Removing adhesive residues
Sanding disk, brush disk, grinding disk, speed
level 4-6
Grinding concrete
Grinding disk, speed level 6
Depending on the operation purpose, choose the
correct grain size:
OPERATION
Removal
Preparation
Finish

Technical Data

Nominal voltage
Rated power
No-load speed (n )
0
Sanding surface
Spindle thread
Protection Class
Weight
Sound pressure level (L
Sound power level (L
Max. vibration emission (a
106 EN
GRAIN SIZE
40 - 60
80 - 120
180 - 240
)
pA
)
wA
)
h

Using the tool

Warning! Only switch the tool on when
its working surface is in full contact
with the workpiece and with an appropriate
dust collection system connected.
1. Switch on the dust collection system.
2. Place the tool on the wall so that the complete
disk is in contact.
3. Open the ventilation throttle
sucked too hard to the surface by the dust col-
lection system.
4. To switch on the tool, push the On/Off
switch 8. Lock the tool in position on with the
lock button 9 where appropriate.
5. Hold the tool firmly with both hands while
working.
6. Move the tool slowly over the drywall in paral-
lel lines, circles or crosswise movements and
successive passes.
7. If the tool is locked in position on, push and let
go the On/Off switch 8
wise simply let go the On/Off switch 8.
8. Unplug the tool after work and before breaks.
230–240 V~ / 50 Hz
1300 W
800 - 1750/min
Ø 180 mm
M14
/ II
3.6 kg
94.6 dB(A) / Uncertainty K = 3 dB(A)
105.6 dB(A) / Uncertainty K = 3 dB(A)
5.159 m/s / Uncertainty K = 1.5 m/s
2
4, if the tool is
to switch it off. Other-
2