J.C. SCHWARZ JTS 180 Mode D'emploi page 105

1 DISK EXCHANGE
Press the spindle lock
the disk, until it locks. Use the
to loosen the flange counter-clockwise.
Warning! Only press the spindle lock
button if the tool is at a complete
standstill.
3 SANDING DISK
Insert the sanding disk without paper. In-
sert the flange with the small inner ring
pointing towards the disk. Press the spin-
dle lock button 3 and tightly fasten the
flange clockwise with the spanner 6.
1 REPLACEMENT OF SANDING PAPER
To remove the sanding paper carefully
peel it off the sanding disk.
Do not use the same sanding paper for
different materials.
1 REPLACEMENT OF BRUSHES
Turn the brush disk over. Press the three
latches of the locking disk toward the
centre of the disk and push out the brush
locking disk downwards.
1 WORKING ALONG EDGES
To work along edges: Remove the screw on
top of the detachable guard 5.
Warning! Use the tool with fitted
guard whenever you are not working
along edges.
2
button 3 and rotate
spanner 6
4
2
2
place.
2
GRINDING DISK
Insert the grinding disk. Insert the flange
so that the small inner ring stays visible.
Press the spindle lock button 3
fasten the flange clockwise with the span-
ner 6.
BRUSH DISK
Insert the brush disk. Insert the flange
with the small inner ring pointing towards
the disk. Press the spindle lock
and tightly fasten the flange clockwise
with the spanner 6.
Align the holes of the sanding paper with
the ones of the sanding disk and press the
sanding paper into place.
Slide the brushes towards the centre of
the disk and lift them up. Click the locking
disk back in place after replacement.
Warning! Only use the brush disk with
locking disk and all brushes fitted in
Lift the detachable guard 5
remove it. Fix it again with its screw after
work.
and tightly
button 3
outside up to
EN 105