When To Change The Thread Catcher Of The Floor Brush Allteq (Depending On Model); Replacing The Thread Catchers; Cleaning And Care; Frequently Asked Questions - Miele SCAE0 Instructions D'utilisation

When to change the thread catcher
of the floor brush AllTeQ (depending
on model)
The thread catcher on the floor brush
AllTeQ can be replaced when the pile
is worn out.

Replacing the thread catchers

(see fig. 33)
^ Use a screwdriver or similar object to
remove the thread catchers from the
slots.
^ Insert the new thread catchers.
New thread catchers can be purchased
from any authorized Miele vacuum
dealer or Miele.
Cleaning the floor roller of the floor
brush AllTeQ, see fig. 34
(depending on model)
a Release the roller pin using a coin.
b Push and take out the roller axle.
c Take out the roller.
^ Remove all threads, hair etc. and
reinstall the roller and lock the roller
pin.

Cleaning and care

,
Turn off the vacuum and unplug
it from the outlet before performing
any maintenance work.
Vacuum cleaner and accessories
The vacuum cleaner and other plastic
accessories can be cleaned with a
damp cloth or a cleaner suitable for
plastics.
,
Do not use abrasive, oil-based,
glass or all purpose cleaners!
Dust compartment
The dust compartment can, if
necessary, be cleaned using a dry
cloth, dusting brush or a second
vacuum to remove any dust.
Monitor the filter bag change indicator
and inspect all filters regularly. Clean or
replace them when necessary
according to these Operating
Instructions.
,
Do not submerge the vacuum in
water. If moisture gets into the
appliance there is the risk of an
electric shock.

Frequently asked questions

The vacuum cleaner shuts off
automatically.
A temperature sensor will turn off the
vacuum cleaner if it becomes too warm.
This problem can occur if, for example,
an object is blocking the suction hose
or the filter bag pores have become
clogged with fine dust. The cause
could also be a heavily soiled exhaust
or dust compartment filter. If this
happens, turn off the vacuum cleaner
(press the On/Off foot switch s) and
unplug the power plug from the
electrical outlet.
Once the cause has been addressed,
allow the vacuum cleaner to cool for
approx. 20 - 30 minutes before
resuming vacuuming.
en
17