Replacing The "Active Airclean" Filter Or The "Hepa" Filter; Exchanging Exhaust Filters; When To Change The Thread Catcher; Changing The Thread Catcher - Miele Swing H1 Instructions D'utilisation

If you would like to use an Active
AirClean or HEPA filter, see

"Exchanging exhaust filters".

^ Put the lid back on and close it.
Replacing the "Active AirClean" filter
or the "HEPA" filter (see fig. 29 + 30)
Make sure that only one exhaust
filter is installed.
^ Press the release button for the
exhaust filter compartment on the
rear of the vacuum cleaner and
remove the lid (see fig. 26).
^ Remove the used "Active AirClean"
filter or "HEPA" filter.
^ Insert the new "Active AirClean" filter
or "HEPA" filter.
If you would like to use an AirClean fil-
ter, see "Exchanging exhaust filters".
^ Put the lid back on and close it.
Exchanging exhaust filters
Depending on the model, one of the
following standard exhaust filters is
installed (see fig. 25).
a AirClean
b Active AirClean (SF-AAC 10)
c HEPA (SF-H 10)
All of the above filters are
interchangeable and the exhaust filter
supplied with the vacuum cleaner can
be exchanged with another type.
Make sure that only one exhaust
filter is installed.
The exhaust filters have different
features (see "Optional accessories").
When changing the filter
1. If you would like to replace filter a
with filter b or c it is essential that you
also remove the filter frame before
inserting the new type of filter.
2. If you would like to replace exhaust
filter b or c with filter a it is essential that
you install a filter frame * in the lid.
* Filter frame - see "Optional
accessories"
Removing or inserting the filter frame
(see fig. 31)
^ Grasp the sides of the filter frame at
the locations shown (see arrows) and
squeeze. The frame can now be
inserted or removed.

When to change the thread catcher

The thread catcher pads on the bottom
of the rug and floor tool should be
replaced as soon as they appear worn.

Changing the thread catcher

(see fig. 32 + 33)
^ Use a screwdriver or similar object to
remove the thread catcher pads from
the slots.
^ Press the new thread catcher into the
slots.
Spare parts may be obtained from from
any authorized Miele vacuum dealer or
Miele.
en
15