Oven Lights; Oven Door - Jenn-Air JMW3430 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Oven Lights

The oven lights are 120-volt, 25-watt maximum halogen bulbs.
They will come on when the oven door is opened. On double
oven models, both upper and lower lights will come on when
either door is opened. The oven lights will not work during the
Self-Cleaning cycle. When the oven door is closed, touch LIGHT
to turn light on or off.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Disconnect power.
2. Remove glass light cover by grasping the front edge and
pulling away from oven.
3. Remove bulb from socket.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage or decreasing the life of the new bulb,
do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into wall.
6. Reconnect power.

Oven Door

WARNING
Excessive Weight Hazard
Use two or more people to move and install oven
doors.
Failure to do so can result in back or other injury.
IMPORTANT:
To avoid oven door glass breakage:
Do not close the oven door if the racks are not fully inserted
into the oven cavity or when bakeware extends past the front
edge of an oven rack.
Do not set objects on the glass surface of the oven door.
Do not hit glass surfaces with bakeware or other objects.
Do not wipe down glass surfaces until the oven has
completely cooled.
For normal oven use, it is not suggested to remove the oven door.
However, if removal is necessary, make sure the oven is off and
cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door to the full open position
2. Locate the oven door latches in both corners of the oven
door and rotate the latches forward to the unlocked position.
A. Oven door latch in locked
position
3. Grasp the edges of the oven door with both hands and close
the oven door until it will no longer close. Lift and pull oven
door toward you and remove.
4. Set the oven door(s) aside on a covered work surface.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the latches back to the locked position. Check that the
door is free to open and close. If it is not, repeat the removal
and installation procedures.
A
B. Oven door latch in unlocked
position
B
23

Publicité

Table des Matières
loading

Table des Matières