Mopar 82208859 Notice D'installation page 8

F. Locate the Black/Yellow wire in pin
#9 of the grey 20-way connector,
found above the steering column.
Center-splice the harness Black/
Yellow wire into this wire.
G. Locate the Black/Red wire in pin #5
of the green 7-way connector,
found below the steering column.
Center-splice the harness Black/
Red wire into this wire.
H. Route the two remaining wires
(Black/White and Grey) through the
cowl panel and into the engine
compartment.
I. Using the supplied butt connector,
connect the Black/White wire to
the remaining wire from the hood
safety switch.
J. Route the Grey wire to the top of
the engine at the coil connection
point as shown. Disconnect the
connector from the coil for easier
connection. Center-splice the
Grey wire to the Black/Grey wire at
the coil. Solder the connection.
Caution: Re-connect the coil
connector when completed.
8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
COIL
1 2 3 4 5 6 7 8