Mopar 82208859 Notice D'installation page 7

3. Install Custom Harness.
A. Locate ignition switch connector on
the left side of the steering column.
Release the red secondary lock.
While pushing on main release,
remove connector from ignition
switch.
B. Connect the harness 10-way female
connector to the vehicle's ignition
switch.
C. Connect the harness 10-way male
connector to the vehicle's 10-way
ignition connector previously
removed from the ignition switch.
D. Using a supplied 1/4" screw, secure
the black ground wire with ring
terminal to the left kick panel metal
as shown in diagram.
E. Run the harness White/Tan wire to
the brake switch. Connect by
center-splice to the White/Tan wire
in cavity #2 of the 6-way brake
connector following the center-
splice procedure above.
Caution: Keep wire away from
the exposed steering column!
Caution: Do not remove the
brake lamp switch from the
mounting bracket. If the switch
is removed from the mounting
bracket, it MUST be replaced
with a new switch.
Center-Splice Procedure
7