Mopar 82209531AB Instructions D'installation

CONTENTS
Sunroof Deflector
Instructions Sheet
Clips
Screws
Washers
Nuts
Abrasive Resistant Tapes
Alcohol Wipe
IMPORTANT: Read all instructions carefully before
beginning the installation.
hElPful hINT
Ensure to use caution when installing the Sunroof
STEP 1
Thoroughly clean installation areas and open the sunroof
window. Trial fit the Sunroof Deflector centrally on roof.
Note the two holes in Sunroof Deflector. Using a non-
permanent felt pen or pencil, mark the positions of the
two holes onto sunroof. Note the tape attachment areas.
Remove Sunroof Deflector. See Figure 1.
STEP 2
Hand tighten the Sunroof Deflector to both clips using the
screws, washers and nuts provided. See FIGURE 2.
STEP 3
Re-fit the Sunroof Deflector and take note where the clips
make contact with the sunroof surface. Remove Sunroof
Deflector and clean the areas with alcohol wipe provided.
Wipe dry with a clean cloth. Adhere the abrasive resistant
tape. See FIGURE 3.
STEP 4
Re-fit the Sunroof Deflector. Make sure the rubber trim is
not folded. The Sunroof Deflector will want to sit off the
roof surface at each corner. This is designed into the part
to ensure proper tension of the part to vehicle roof.
See FIGURE 4.
x1
x1
x2
x2
x2
x2
x2
x1
Deflector.
1
2
ABRASIVE RESISTANT TAPE
CLEANED AREA
1 2
3
4
SG562b
1/6
K6859751
ROOF
CLIP
ABRASIVE
RESISTANT
TAPE