Mopar 82208859 Notice D'installation page 11

Option Programming - continued.
E. Pressing and releasing the programming button again will put the system
into Option Bank 2. The horn will chirp and the lights will flash 5 times
indicating the system has entered Option Bank 2.
F. Press and release the brake pedal to cycle through the options in Bank 2.
Notes:
1. Once the system has reached the last option in a bank, pressing and
releasing the brake pedal will return back to option 1 in that bank.
2. Once the system has reached Option Bank 2, pressing and releasing the
programming button will return back to Option Bank 1.
3. To reset options back to their default setting, while in option learn mode,
push and hold the transmitter button until the horn chirps and lights flash
5 times.
3. Tach Rate Programming (Required for system to operate).
A. Close hood.
B. Turn the ignition to the "on" position.
C. Press and hold the programming button. After 10 seconds the horn will
chirp and the lights will flash 3 times.
D. Release the programming button.
E. Press and release the programming button again. The horn will chirp and
the lights will flash 4 times indicating the system has entered Option Bank
1.
F. Press and release the programming button again. The horn will chirp and
the lights will flash 5 times indicating the system has entered Option Bank
2.
G. Advance to option 2 by pressing and releasing the brake pedal 2 times.
The horn will chirp and the lights will flash 2 times indicating the system is
at option 2.
H. Start the vehicle with the key. The horn will chirp and the lights will flash
once approximately every 3 seconds indicating a valid tach signal.
I. Once the engine has settled to a normal idle speed, press and release the
brake pedal to set the tach rate.
J. Turn the ignition off.
Note:
If the system is not chirping the horn and flashing the lights every 3 seconds
after the ignition has started, the system is not seeing a valid tach signal.
Check your tach connection (Black/Grey at coil). Repeat the
Tach Rate Programming procedure.
Tach Rate Programming must be done before the SKIM learn procedure.
11