Install The Grass Catcher; Install The Mulch Plug; Install The Side Discharge Chute; Set The Blade Height - GreenWorks Pro LMC410 Manuel Opérateur

2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.4

INSTALL THE GRASS CATCHER

Figure 4.
1. Remove the mulch plug.
2. Remove the side discharge chute.
3. Open the rear discharge door and hold it.
4. Hold the the grass catcher by its handle and engage the
hooks on the door rod.
5. Close the rear discharge door.
3.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
3.6 INSTALL THE SIDE DISCHARGE
CHUTE
Figure 6
CAUTION
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door and hold it.
2. Line up the recesses of the side discharge chute below the
pivot.
3. Close the side discharge door.
3.7

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 7.
1. Pull the height adjustment lever rearward to increase the
blade height.
2. Pull the height adjustment lever forward to decrease the
blade height.
3.8

INSTALL THE BATTERY PACK

Figure 8.
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The engine starts only when you put in the safety key.
3.9

REMOVE THE BATTERY PACK

Figure 8.
1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 9.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the
direction of the handle bar.
4. Release the start button to start the machine.
Soft-Start
This Li-ion machine has a "soft-start" feature.
When you start the machine, it goes to full speed after
approximately 3 seconds.
If the machine does not start, remove the battery pack and
examine the mower deck to make sure that:
• no grass catches on the blade.
• the blade can turn freely by hand.
5
WARNING
NOTE
WARNING
NOTE
EN