Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting instructions
All the operations of the controller are focused on the operation panel.
The green light indicates the state of POWER.
The red light indicates the current working MODE.
The yellow light indicates a fault (in water, in pump or in pipe).
A long press on MODE key allows to switch from different working
mode:
MODE1 means intelligent working mode
MODE2 means pressure control mode
When the controller is in MODE1, press the down button " " for 4
seconds and the interface display flickers the starting pressure "L*.*";
then the starting pressure value can be adjusted up or down using the
buttons (
/
).
When the controller is in MODE2, press the up button " " for 4 seconds
and the interface display flickers the upper limit of the pressure value.
At this point, the pressure limit can be adjusted up or down using the
buttons (
/
).
Press the down button " " for 4 seconds and the interface display
flickers the lower limit of the pressure value.
At this point, the lower limit can be adjusted up or down using the buttons
(
/
).
When the pump is out of water, the yellow LED indicator will flash.
The pump can be restarted by pressing the RESET button.
Page 15 / 24
Publicité
Table des Matières
