Maintenance And Cleaning - Volpi KV360 Mode D'emploi

14.1. Cutting control mode
The KV360 electric pruning shears has two cutting control modes:
Non-progressive cutting control
Progressive cutting control
NON-PROGRESSIVE CUTTING CONTROL
When the pruning shear is turned on, the non-progressive cutting control is predetermined, that is,
when the trigger is actuated the blade performs the cutting action, and when the trigger is released the
blade opens.
PROGRESSIVE CUTTING CONTROL
To change the control mode, you must hold the trigger for 2 seconds until you hear an audible warning
(a beep), which indicates that you have changed from normal cut control mode to progressive cut
control mode.
In the progressive cutting control, the blade moves according to the depth of the trigger drive, that is, if
the trigger is activated halfway, the blade moves progressively halfway through its opening.
14.2. Opening change (only in progressive mode)
The KV360 shears incorporates a system of change of opening with memory.
It means that we can adjust the opening of the head in function of the diameter of cut
wished.
In the progressive cutting control mode, the cutting diameter can be adjusted and a smaller
cutting diameter can be set, for which the position of the blade at the desired cutting
diameter must be maintained for 1 second and an audible warning will sound (a beep)
indicating that the selected cut-off opening diameter has been memorized.
Press the trigger twice in rapid sequence to activate the pruner and a confirmation tone will sound.
To return to full open, keep the trigger pressed until you hear two beeps, one single then
three in sequence, indicating that the opening memory has been removed.

15. Maintenance and cleaning

Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining and repairing the pruning
shear, to avoid risk of unexpected activation of the tool.
37