Volpi KV360 Mode D'emploi page 41

Turn the hexagon screw of the blade clockwise
I.
as shown in the picture. Press the plastic cap.
M. Screw the M5 hexagon socket countersunk
head counterclockwise as shown.
15.4. Tool Calibration
If a replacement motor or drive plate is required, the pruners need to be recalibrated.
Follow next steps to perform the calibration:
1) Remove the upper and lower blades.
2) Insert the battery.
3) Hold down the trigger and keep it pressed. Press the POWER switch again.
4) Maintain the trigger pressed for more than 10 s.
5) Release the trigger when you hear the motor turning.
6) The electric motor rotates during calibration. When the motor stops turning the calibration is
complete.
7) Reassemble the blades as indicated in chapter 15.3
I
L. Place the flat needle roller bearing as shown
and screw on the locking nut.
M
N. Reduce the friction between the two plans of
the blades by adding grease through the hole of
the plastic cap as shown in the figure.
L
N
41