Speedaire 1NNF8 Instructions D'utilisation Et Manuel De Pièces page 3

Speedaire Operating Instructions and Parts Manual
Model 1NNF8
Assembly
FOOT ASSEMBLY
The items marked with an asterisk (*)
are included in separate parts pack (See
Figure 1).
Shoulder Bolt*
Foot*
Lock Nut*
Bolt*
Figure 1 - Foot and Wheel Assembly
1. Insert bolt through foot and
bracket. The foot should be on the
lower side of bracket.
2. Tightly secure bolt. Repeat on
opposite side.
WHEEL ASSEMBLY
The wheels were shipped loose with the
unit (See Figure 1).
1. Insert shoulder bolt through wheel
hub. The bolt hex head should be
on the opposite side of protruding
hub center.
2. Feed the shoulder bolt through the
hole on the tank axle iron and
tightly secure with the locknut.
Repeat on the opposite side.
Installation
LOCATION
The tank must sit level or slope slightly
towards the drain valve to allow the
tank to drain properly.
It is extremely important to install the
compressor in a clean, well ventilated
area where the surrounding air
temperature will not be more than
100°F.
A minimum clearance of 18 inches
between the compressor and a wall is
required because objects could obstruct
air fl ow.
Wheel
the compressor air inlet near steam,
paint spray, sandblast areas or any other
source of contamination. This debris will
damage the motor.
ELECTRICAL INSTALLATION
and electrical connections should be
performed by a qualifi ed electrician.
Installation must be in accordance with
local codes and national electrical codes.
Never use an extension
cord with this product. Use
additional air hose instead
of an extension cord to
avoid power loss and permanent motor
damage. Use of an extension cord voids
the warranty.
GROUNDING INSTRUCTIONS
1. This product is for use on a nominal
120 volt circuit and has a grounding
plug that looks like the plug
illustrated in Figure 2. Make sure
the product is connected to an
outlet having the same
confi guration as the plug. Do not
use an adapter with this product.
This product must be grounded.
Figure 2
Do not
locate
All
Improper use of grounding
wiring
plug can result in a possible
risk of electrical shock!
grounding adapter with this product!
2.
STOP!
green (or green and yellow) wire to a
live terminal.
3.
3
Grounded
Outlet
TEST RESET
Grounded Pin
In the event of an electrical short
circuit, grounding reduces risk
of electrical shock by providing an
escape wire for electric current.
This product is equipped with a
cord having a grounding wire with
an appropriate grounding plug.
Cord must be plugged into an outlet
that is properly installed and
grounded in accordance with all
local codes and ordinances.
Do not
use a
If repair or replacement of cord
or plug is necessary, do not connect
grounding wire to either fl at blade
terminal. The wire with insulation
having an external surface that is
green (with or without yellow
stripes) is the grounding wire.
Never
connect
Check with a qualifi ed electrician
or serviceman if grounding
instructions are not completely
understood, or if in doubt as to
whether product is properly
grounded. Do not modify plug
provided; if it will not fi t outlet,
have proper outlet installed by a
qualifi ed electrician.
E
N
G
L
I
S
H
®