Using The Panel For The First Time; Care And Cleaning; Start; Setting The Desired Bathing Temperature - Tylo h1 Mode D'emploi

Using the panel for the first time

Using the panel for the first time
Using the panel for the first time Using the panel for the first time
The first time you use h1, you will need to make a number of basic settings:
1. Enter your region (Europe, USA, Other). Use up/down arrows. Confirm with OK.
2. Select language. Use up/down arrows. Confirm with OK.
3. Set correct product (sauna/steam bath). Use up/down arrows. Confirm with OK.
4. Set desired running time (1 to 23 hrs). Confirm with OK.

Care and cleaning

Care and cleaning
Care and cleaning Care and cleaning
Clean the glass with window cleaning detergent and a soft cloth.

Start

Start
Start Start
To start the sauna heater/steam generator, move your hand in front of the screen. The on/off
symbol will light up. Press OK. The on/off icon lights up in the status display (5) to indicate that
the heater/generator has been switched on. If (1) does not light up, press the "up" arrow to
move to the appropriate position. To switch off, move to (1) and press OK.
When the sauna heater/steam generator is operational, the current temperature and time will
be displayed, unless any settings have been changed.
When the sauna heater/steam generator is switched off, the control panel dims.
To reactivate the panel, simply move your hand in front of the screen.

Setting the desired bathing temperature

Setting the desired bathing temperature
Setting the desired bathing temperature Setting the desired bathing temperature
Use the up/down arrows to highlight the temperature symbol (2) and press OK. Set the desired
bathing temperature by using the up/down arrows and confirm with OK.

Setting the desired start time

Setting the desired start time
Setting the desired start time Setting the desired start time
You can preset a switch-on time for the sauna heater/steam generator up to 24 hours in
advance.
Use the up/down arrows to highlight the clock symbol (3) and press OK. Select Start Time and
enter the desired time by using the up/down arrows. Confirm each figure by pressing OK.
When a start time has been programmed, this is indicated by a small clock icon in the status
display's basic menu.
A previously programmed time can be activated by moving to Activate under the clock symbol
and confirming with OK.
To deactivate a programmed time go to (3). Then use the "down" arrow to move to Activate
and confirm with OK.
13