DELTACALOR TELICA CINTRE Notice D'utilisation Et D'installation page 54

Pilot wire control
Pilot wire
command
Confort
CLr - Delete the unit's memory with the factory settings.
All the thermostat settings will be loaded with the factory
settings. Press and hold
If you press and hold
restore the settings.
The thermostat is reset to the predefined factory settings:
• Set the temperature to 19°C
• Programme from U1 to U4,
• Increase by 30 minutes
User settings:
• Time displayed "24H",
• Temperature unit "°C",
Detection of open window "Yes", - ITCS (time of start- adaptive
heating) "Yes", - sensor calibration "no",
• Automatic daylight saving time setting "Yes",
• Boost set point 30°C,
• Maximum comfort set point 30°C,
• Child protection "no" (100%),
• Reset the time.
NOTE: Heater power setting is not reset.
A software version
Exit the settings menu
Pressing the
operation.
Screen
for a few seconds.
for 5 seconds, the thermostat will
, 17°C
.
key exits the return settings menu during normal
Pilot wire
command
ECO
[ 54 ]
, 7°C,
Screen