Led Indicators And Troubleshooting; Led Indicators - Belden Hirschmann OZD Genius G12 Serie Manuel

4 LED Indicators and Troubleshooting

4 LED Indicators and Troubleshooting

4.1 LED indicators

OZD Genius G12
System
Port 1
Port 2
Port 3
1 0
Fig. 17: LED indicators on front panel
LED indicator
System Green
Not lit
Red
Port 1 Green
Not lit
Orange
Port 2 Green
Not lit
Orange
Port 3 Green
Not lit
Orange
Note – "Unlit" port LEDs do not indicate a fault.
– Flashing LEDs indicate that an incorrect data rate has been set/detected at an OZD Genius device or at a bus device.
39
LED indicators
Possible causes
– Repeater in operation, data traffic occurring
– No voltage supply
– Internal device fault
– No data received at Port 2 and/or Port 3 (e.g. cable breakage)
– Input signal supplied
– No signal currently being received at this port
– No signal currently being received at all three ports
– Input signal supplied
– No signal currently being received at this port
– No signal currently being received at all three ports
– Input signal supplied
– No signal currently being received at this port
– No signal currently being received at all three ports
4.1 LED indicators
Signaling contact
No signal
Signal
Siignal
No signal
No signal
Siignal
No signal
Siignal
Siignal
No signal
Siignal
Siignal
Version 05 07/2014