Using Your Total Crushing Blender Pitcher - Ninja Intelli-Sense CT680SSCCO Instructions

USING YOUR TOTAL CRUSHING®
BLENDER PITCHER
IMPORTANT: Review all
warnings on pages 3–6
before proceeding.
TIP: If the Stacked Blade
Assembly is not fully
seated, you will not be
able to install and lock the
lid.
TIP: To learn more about
the unit's programs, refer
to page 10.
NOTE: Pre-set programs
have pauses and changes in
speed throughout the cycle.
NOTE: DO NOT add
ingredients before completing
installation of the Stacked
Blade Assembly.
1
NOTE: The pitcher can only Place the unplugged motor
base on a clean, dry, and
be installed in one orientation.
level surface such as a
The handle must be
countertop or table. Press
positioned on the front-right
downward on the motor
corner of the motor base to
base to adhere the suction
operate the appliance.
cups to the work surface.
Ensure the motor base is
connected to power.
13
1-877-646-5288
2 Lower the Total Crushing
Blender pitcher onto the
motor base. The handle
should be aligned slightly
to the right and the pitcher
should be oriented so the
LOCK symbols are visible
on the motor base. Then
rotate the pitcher clockwise
until it clicks into place.
3 Exercising care, grasp the 4 Add ingredients, making
Stacked Blade Assembly sure to not exceed the
by the top of the shaft and Max Fill line marked on the
place it onto the drive gear side of the pitcher.
inside the pitcher. Note
that the blade assembly
will fit loosely onto the
drive gear.
5 Place the lid on the pitcher,
aligning the triangle symbol
located on the lid with the
triangle symbol located on
the pitcher's handle. Press
down on the handle until
it clicks into place. The
triangle symbols MUST
be aligned for the lid to
lock onto place and the
unit to operate. When
the unit is connected to
power and the container
is correctly locked into the
motor base, the available
program buttons will
illuminate and the unit will
be ready for use.
14
n i n j a k i tc h e n . c o m