Auto-Iq Programs For The Precision Processor™ Bowl; Manual Programs; Using The Total Crushing Pitcher - Ninja BN800C Série Guide De L'utilisateur

FEATURES - CONT�
AUTO-IQ PROGRAMS FOR THE
PRECISION PROCESSOR™ BOWL
CHOP
Timed pulses and pauses to give
you consistent chopping results.
DOUGH
Ideal for creating delicious dough
for pizza, bread, and baked goods
like cookies.
10 ninjakitchen.com

MANUAL PROGRAMS

LOW, MEDIUM, and HIGH
When selected, each of these speeds runs
continuously for 60 seconds. Press the
currently active button again to stop the
program sooner. They do not work in
conjunction with any Auto-iQ programs.
PULSE
Offers greater control of pulsing and
blending. Operates only when PULSE is
pressed. Use short presses for short pulses
and long presses for long pulses.
USING THE TOTAL CRUSHING® PITCHER
IMPORTANT: Review all warnings
on pages 4–6 before proceeding.
IMPORTANT: As a safety feature, if the
pitcher and lid are not properly installed,
the timer will display "... ..." and the
motor will be disabled. If this happens,
repeat step 5 on the following page.
When the pitcher and lid are properly
installed, the program button LEDs will
illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ® programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The pitcher lid handle will not fold
down unless it is attached to the pitcher.
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Lower the Total Crushing Pitcher onto
the motor base. The handle should
be aligned slightly to the right and the
pitcher should be oriented so the LOCK
symbols are visible on the motor base.
Rotate the pitcher clockwise until it
clicks into place.
3 Exercising care, grasp the Stacked
Blade Assembly by the top of the shaft
and place it onto the drive gear inside
the pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the MAX LIQUID
line on the pitcher.
ninjakitchen.com 11