Service Information - Black & Decker LST220 Mode D'emploi

drop off the spent battery.
RBRC™
Rechargeable Battery Recycling Corporation.
MAINTENANCE
WARNINg:
To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
TROUBLESHOOTINg
TOOL RUNS SLOWLY
• Remove battery from tool.
• Check that the spool housing can rotate freely. Carefully clean it if
necessary.
• Check that the cutting line does not protrude more than
approximately 5-3/8 inches (136mm) from the spool. If it does, cut
it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK
• Remove battery from tool.
• Remove the spool cap.
• Pull the cutting line until it protrudes approximately 5-3/8 inches
(136mm) from the spool. If insufficient cutting line is left on the
spool, install a new spool of cutting line.
• Ensure that the line is not crisscrossed on the spool as detailed
in figure 17. If it is, unwind the cutting line, then wind it back on
is a registered trademark of the
the spool neatly so that the lines do not cross.
• Push the spool onto the housing until it snaps securely into place.
• Align the tabs on the spool cap with the cut outs in the housing.
• If the cutting line protrudes beyond the trimming blade, cut it
off so that it just reaches the blade. If the automatic line feed
still does not work or the spool is jammed, try the following
suggestions:
• Carefully clean the spool and housing.
• Remove the spool and check if the lever in the spool housing
can move freely.
• Remove the spool and unwind the cutting line, then wind it on
neatly again. Replace the spool into the housing.

SERvICE INFORMATION

All BLACK+DECKER Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power
tool service. Whether you need technical advice, repair, or genuine
factory replacement parts, contact the BLACK+DECKER location
nearest you. To find your local service location, call: 1-800-544-6986
or visit www.blackanddecker.com
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
12