Nolan N62 Sécurité Et Instructions D'utilisation page 9

- Never use the helmet prior to having correctly and completely refitted the inner comfort padding
and the cheek pads.
- Never machine-wash the inner comfort padding.
- Never use tools or equipment of any sort to carry out the steps described above.
• NFRS - NOLAN FOG RESISTANT SYSTEM
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the external levers for the
pin adjustments are turned towards the inside (see photo 8).
1.3 Remove the protective film from the inner visor on the side in contact with the visor.
1.4 Rest one side of the inner visor onto one of the visor pins and hold it in position, see Fig. 6.
1.5 Widen the visor and fasten the other side of the inner visor to the second pin, see Fig. 7.
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor and check that the inner visor profile
adheres to the visor.
1.8 Fix the visor onto the helmet.
CHECKING AND ADJUSTING THE INNER VISOR AIR DRAUGHT
Check for correct system fitting, by opening and closing the visor and check that both visors are cor-
rectly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simultaneously
upwards to increase the air draught (Fig. 8). This operation must be carried out gradually. The maxi-
mum air draught is achieved when the external levers for the pin adjustment are turned outwards .
WARNING!!!
The presence of dust between the visors can produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be changed.
Regularly check the correct air draught of the inner visor to prevent the same from moving and scrat-
ching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both for system cor-
rect fitting and air draught.
An excessive and early air draught of the inner visor may result in excessive adherence against visor
surface and/or permanent deformations with subsequent inability to perform following adjustments
correctly.
The extended use in special weather conditions may reduce system performance and result in partial
fogging and problems of condensation on the inner visor. In this case, remove the inner visor from the
helmet visor and dry it with dry and lukewarm air.
2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor and unhook the inner visor from the pins Fig. 7.
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it with neutral liquid
soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry in a ventilated
and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
9