Nolan N52 Sécurité Et Instructions D'utilisation page 8

INSTRUCTIONS FOR USE
1 PEAK
Attention!!!
When riding on the road, the peak has to be adjusted to the highest position (see
Position 1 in fig. 1).
1 Adjustment
1.1 Release central latches A by turning them as in Fig. 2 (latches stay attached to the
peak thanks to trims).
1.2 Rotate the peak on the side latches B to find the desired position which is the highest
one when riding on the road (see Position 1 in Fig. 1).
1.3 Lock the peak in the desired position by rotating latches A in the reverse direction until
they return to the original position (Fig. 2).
2 Disassembly
Release latches A and B by rotating them as shown in Fig. 2 to completely remove the
peak from the helmet shell.
3 Assembly
3.1 Check that latches and the relevant internal trims are correctly hooked to the peak as
in the beginning.
3.2 Place the peak on the shell making sure that latches A and B are inserted in the cor-
responding slots.
3.3 Lock latches B by rotating them until they return to the original position (Fig. 2).
3.4 Adjust the peak as described in step 1.
2 REMOVABLE INNER COMFORT PADDING
1 How to remove the inner comfort padding
1.1 Open the chin strap (see specific instructions) and pull a cheek pad from the front
towards the inside of the helmet to extract it from the chin guard and the inner shell
(Fig. 3).
Attention: when disassembling, hold the chin guard firmly in place as shown in Fig. 3C.
If the chin guard comes out of its fastenings (D and E), reposition it as in the begin-
ning (Fig. 4).
1.2 Extract the cheek pad from the helmet by pulling out the chin strap from the slot on
the cheek pad (Fig. 5). Repeat the same steps with the other cheek pad.
1.3 Unhook the left rear fastening flap from the support fixed to the inner shell by slightly
deforming the shell sealing edge and slightly pulling the comfort padding in the hel-
met neck-ring area towards the inside (Fig. 6). Follow the same steps with the central
and right flaps.
8