Reset To Factory Settings - Roco Z21 Mode D'emploi

By pressing the button once again for at least 3 seconds, the setting is assumed and the device moves to
the next option. This is signalled by the illumination of the blue LED. Once the final option has been assu-
med, the device leaves the configuration mode and all settings are saved. The track output is automatical-
ly re-activated after 3 seconds.

Reset to factory settings:

If it is necessary to reset all settings to the factory settings, simply press the button for longer than 6
seconds until all LEDs illuminate and the blue LED flashes. This triggers the reset. The track output is once
again automatically activated after 3 seconds.
Configuration option:
RailCom
This option can activate/deactivate the RailCom
gap (activated as standard).
Auto inversion
This option activates auto inversion which causes
an automatic polarity reversal of the track signal
if the booster is used as a terminal loop module
for example. However, it is also practical to not
always have to pay attention to the track polarity
(activated as standard).
Short circuit notification
The notification of short circuits to the control
centre is not performed when this option is
deactivated. However, this booster switches off
in the event of short circuits and automatically
attempts to re-activate the track output every 3
seconds (activated as standard).
8010805920 V_2016.indd 17
ATTENTION: This option must be
deactivated if neighbouring booster
sections do not generate a RailCom
gap (10761, 10764, 10768, 10830,
10832, 10762, 10765 are unable to
work with RailCom).
ATTENTION: In terms of
neighbouring booster sections, only
one of the two boosters may have an
active auto inversion as both units
would otherwise reverse the polarity
simultaneously which would lead to a
short circuit.
GB
17
15.04.2016 10:51:09