Configuration - Roco Z21 Mode D'emploi

GB
You can configure and operate the booster via the button. Activate / deactivate track
output:
If the booster is in normal mode (the blue LED is steady), the track output can be
switched off by briefly pressing the button (the blue LED flashes). The track output is
re-activated by briefly pressing the button once again.

Configuration:

In order to move into configuration mode, the button must be held for at least 3 seconds
until the white „Config" LED begins to flash (the track is deactivated in configuration
mode). In doing so, the „Config" LED displays the currently selected option.
Flashes white once
Flashes white twice
Flashes white 3 times
The selected option can be activated or deactivated by briefly pressing the button.
This is signalled via a green LED for „activated" or a red LED for „deactivated".
16
8010805920 V_2016.indd 16
Connection as a terminal loop
Buttons and configuration
Option 1: RailCom
Option 2: Auto inversion
Option 3: Notification of short circuit to the control centre
Information: If the booster is
used as terminal loop module, „auto
inversion" must be activated (please
refer to the Configuration Chapter for
further information).
15.04.2016 10:51:09