Applications; Technical Specifications; English - jbc IN 2100 Mode D'emploi

We appreciate the trust you have shown in JBC by purchasing this IN 2100 Ref. 2132058,
soldering gun. It has been manufactured with the highest standards of quality to ensure
reliable service.
It is equipped with a long life tip. See the models on the last page.

APPLICATIONS

Soldering of electronic components for home
repair calls or for use as a source of quick and
powerful heat.

TECHNICAL SPECIFICATIONS

- Power supply:
- Initial power:
- Maintenance power:
- Fast heating
reaches 250°C:
- Long-life tip T-20D:
- Weight:
This product should not be thrown in the
garbage.
OPERATING INSTRUCTIONS
Check that mains voltage is the same as indi-
cated on the soldering gun handle.
Plug in the soldering gun and press the trigger
without releasing for about 30 seconds. The
temperature will keep rising by its own inertia.
Then press the trigger at intervals of approx. 10
seconds to maintain temperature.
If the soldering job requires high temperature
or if a great deal of heat dissipation is foreseen
(ground solder), make an initial contact of ap-
prox. 1 minute, then press the trigger again, this
time for as long as the soldering gun tip remains
in contact with the point to be soldered.
Do NOT keep the trigger pressed for the whole
time that the soldering gun remains in operation
or the tip will overheat and wear out quickly.
Remember that the soldering flux evaporates at
very high temperatures before its cleaning action
has time to take effect, thus failing to do the job
for which it is intended.
230 V
200W
60W
in approx. 45 seconds
Ref. 0300509
150 g
The coil spring which is supplied with the unit
serves as protection when storing the hot sol-
dering gun (Fig. 1) and as support while working
(Fig. 2).
Fig. 1
Fig. 2
1

ENGLISH