Location Of The Appliance - Plein Air TV-SP 2000 Mode D'emploi

INSTRUCTION FOR USE
CAUTION: Do not touch the unit during operation, because the heater overheats. In order to avoid
burns, prevent contact with skin. Always use the device in a vertical position, observing the precautions
mentioned above. The indicator light ON indicates that appliance is working.
Switching on the appliance
Turn the ON / OFF knob on the positions I or II.
Turn the thermostat control clockwise to the required position (during the first use, you might feel a slight
smell, is a normal reaction due to the first power unit. If very strong smell, ventilate the room).
POSITION
Power level
This appliance is provided by two settings: High and Low.
Use the High position "II" to rapidly increase the temperature in the room. When it reaches the desired
temperature, use the Low position "I" which is usually sufficient to maintain a comfortable temperature.
Adjusting the thermostat
After turning on the device and the room has reached the desired temperature, slowly turn the thermostat knob
counter-clockwise until the heater shuts off (you should hear a faint click). Leaving the thermostat in this
position, the appliance will automatically maintain the temperature constant.
To decrease the temperature, turn the thermostat counterclockwise.
To increase the temperature, turn the knob clockwise.
Only for summer ventilation functioning
Turn the ON / OFF knob clockwise to the ventilated position and turn on the thermostat for summer ventilation
function.
Switching off the appliance
Turn the knob to the left on the "0" position before disconnecting the appliance. You will hear the indicator
light switching off.

LOCATION OF THE APPLIANCE:

Wall mounting
The appliance must be fixed to the wall. Make sure that the opening of the air inlet is facing downward. The
appliance must be placed at a minimum height of 1.8 meters from the ground. Realize two holes (same diameter
dowels) on the wall at the distance indicated in the DIMA present inside the packaging (18.7 cm).
Insert the screws into the anchors and hang the fixture.
The air outlet grid should have a minimum clearance of 1 m, while lateral sides must have a free space of at
least 40 cm. WARNING: The appliance must be installed so that switches and other control devices can not be
touched by a person who is in the bathtub or in the shower.
DT Istr. (TV-SP2000) 04/2014_Rev. 3_04/2017
Summer ventilation
Low power(1000W)
I
High power (2000W)
II
ON/OFF
0
FUNCTION
TV-SP2000
11/12