Domo DO42323PC Notice D'utilisation page 12

Don´t leave the pot switched on without supervision. Turn off the appliance

and remove the plug from its socket, when you want to clean the pot or when it
is not in use.
Do not pull the power cord or use the cord as a handle. Do not close a door

with the power cord in between and don't pull the cord around corners or sharp
edges.
Don´t move when the pot is filled with water.

After usage, unplug the power cord, let the pot cool down and pour away the

water.
Before usage, check if the voltage stated on the appliance corresponds with the

voltage of the power net at your home.
Always unplug the power cord from its socket if you want to clean the

appliance or assemble it.
Waranty can not be held on mechanical damages caused by wrong usage

(broken off pouring tap, crushed body of pot by fall...).
The appliance is designed and built as a whole. Don´t try to disassemble or

modify it.
Never place this appliance near water where it can fall. Always pour the water

into the body of the pot. Don´t leave liquids in the pot when it is not in use.
Place the device on a heat resistant surface and at a distance of approximately

20 cm of the walls.
Packing material, such as plastic bags are not toys for children. Keep the

plastic bags away of children.
Parts:
1. Plastic lid
2. Handle (heat resistant)
3. Body (depends on type of pot)
4. Drain cock (placement depends on type of pot)
5. Base with control panel
6. Switch on/off sound (reach of the temperature)
7. Temperature setting knob
8. Indicator light
9. Timer setting knob
10. Grate
!!! The rocker switch (6) switches off only the acoustic signal when the set temperature is reached !!!!
Before use

Unpack the unit and check whether is not damaged by transport.

The device comes with a disposable drain cock that needs to be unpacked and properly attached
before using it for the first time.
Installing the pouring tap:

Remove all parts of the tap from packaging. On the main part of the tap to put 1 piece a rubber seal.

The prepared tap put through the hole in the body of the pot and from the inner side put the second
rubber seal. Screw the nut and tighten firmly

The cock is equipped with an plastic stopper, which optionally use..

Opening / closing of the cock is done by moving the upper lever forward.