Overview Of The Components / Delivery Scope; Unpacking The Device; Notes On Use; Multifunction Button - BOMANN BS 1949 A CB Mode D'emploi

CAUTION:
• The ambient temperature should be between 0 °C and max. 45 °C.
Heat damages the rechargeable battery. Increasingly lower tem-
peratures reduce the capacity and the life of the rechargeable
battery.
• Do not charge the rechargeable battery unsupervised.
• Use only the mains adapter "ZD12D265050EU" included in the
scope of deliveries.
• Disconnect the power supply unit from the mains when you will
not use the device for a longer time.

Overview of the Components / Delivery Scope

1 Button for unlocking / locking the fi lter unit
2 LED charge indication

3 Multifunction button

/ + / –
4 Carrying handle
5 Socket for connection of the power supply unit
6 Dust collector base plate
7 Dust collector with HEPA fi lter
8 Lock of the dust collector
9 Opener of the dust collector

10 Suction tube

11 Unlocking the fl oor nozzle
12 Button for unlocking the brush roller

13 Floor nozzle with turbo brush

14 Unlocking for suction pipe or nozzle attachment
15 Adapter for the nozzle attachment
16 Combined crevice / brush nozzle
17 Upholstery brush
18 Wall holder
Not shown:
1 x Mains adapter
2 x Wall plug
2 x Screw

Unpacking the Device

1. Remove the device from its packaging.
2. Check the delivery scope for completeness.
3. Check the device for any transport damage, in order to
prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged device!
4. Remove the transport lock from the multifunction button.
42
BS1949ACB_IM
All manuals and user guides at all-guides.com
• The device is especially suitable for quickly vacuuming
• The device is operated via charged battery. Charging is
• Direct power supply via mains adapter is not possible.
Multifunction Button (
Use the multifunction button to turn the device on and off.
Also select a power level with this button.
Press once
Press twice
Press three times = Turn off the device
Suction Tube
• Insert the suction pipe with the two contact pins into the
• To disconnect the suction pipe, press the release (14) and
Floor Nozzle with Turbo Brush
The fl oor nozzle is suitable for any fl oor covering. During
operation, the LEDs on the fl oor nozzle light up for better
visibility in dark areas.
You cannot replace the LEDs.
• Slip the lower end of the suction pipe onto the connector
• To release the suction pipe, push the release (11) away

Notes on Use

small amounts of dry dirt or dust.
done via the supplied power supply unit.
/ + / –)
= Turn on the device, low power level
= Select high power level

Start-up

connection on the hand unit. It must audibly engage.
pull out the pipe at the same time.
CAUTION:
on the fl oor nozzle. Pay attention to the contact pin. The
suction pipe must audibly engage.
from the suction pipe and pull out the pipe at the same
time.
20.10.16