Overview Of The Components; Using The Appliance - BOMANN BS 9022 CB Mode D'emploi

• Do not suck up liquids!
• Do not suck up hot ashes or pointed or sharp objects!
• Do not use the device in damp rooms!
• Never use without the filter. Check that the filter is inserted correctly!
• Hair, clothing and body parts away from the vacuum nozzle during
use!
• Keep the vacuum cleaner away from sources of heat like radiators,
ovens, etc.!

Overview of the Components

1 Suction hose
2 Air control
3 Telescopic suction tube
4 Connection head of the vacuum hose
5 Hose connection
6 Dust collector with HEPA filter
7 Carrying handle
8 Dust collector release button
9 Cable-winding button
10 On/off switch
11 Positioning aid
12 Lever for opening the ventilation grille (with output filter)
13 Dust collector base plate
14 Lever for extending and retracting the brushes
15 Floor nozzle (with hook (not shown))
Accessories not shown:
Groove and brush nozzle
Start-up
• Insert the connecting head of the suction hose into the
hose connection of the appliance. Turn the connecting
head clockwise to secure.
• In order to disconnect the hose, turn the connecting head
anti-clockwise.
• Insert the vacuum tube into the handle if required.
• You can use the sliding switch on the telescopic suction
tube to adjust the length individually.
• Then assemble the floor nozzle and/or the accessories.
Nozzle Attachment
Floor nozzle (15)
The floor nozzle is fitted with rollers for easier guiding.
You can clean smooth surfaces and carpets with the floor
nozzle.
BS 9022CB_IM
• Adjust the brushes outwards or inwards using the lever (14).
Best use of the appliance depends on the texture of the floor
covering. We recommend the following use:
• Use without brushes:
For vacuuming floor coverings with a deep pile
• Use with brushes:
For vacuuming smooth floors and carpets with a shallow
pile
Crevice and jointed nozzle
For vacuuming upholstery, curtains and in corners and crevices
etc.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.

Using the Appliance

1. Unwind the length of cable you require.
CAUTION:
• Pull out the cable up to the maximum length indi-
cated with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the help of
the cable winding button back to the yellow mark.
2. Insert the mains plug into a correctly installed power socket.
3. Turn the device on by the on/off switch by pressing down
the button.
31
24.11.2015