Transport; Set-Up; General Information; Acoustic Emissions - Dimplex SI 6TU Instructions D'installation Et D'utilisation

English
5

Transport

A lift truck is suited for transporting the unit on a level surface.
Carrying straps may be used if the heat pump needs to be
transported on an uneven surface or carried up or down stairs.
These straps can be passed directly underneath the wooden
pallet.
CAUTION!
The heat pump is not secured to the wooden pallet.
CAUTION!
The heat pump must not be tilted more than 45° (in any
direction).
Use the holes provided in the sides of the frame to lift the unit
without the pallet. The side panel assemblies must be removed
for this purpose. Any commercially available length of pipe can
be used as a carrying aid.
CAUTION!
Do not use the holes in the panel assemblies for lifting the
device!
EN-4
6

Set-up

6.1 General Information

The brine-to-water heat pump must be installed in a frost-free,
dry room on an even, smooth and horizontal surface. The entire
frame should lie directly on the floor to ensure an adequate
soundproof seal. If supporting feet are used, the heat pump
must be installed horizontally. In this case, the specified sound
level can be up to 3 dB(A) higher, and additional sound insula-
tion measures may be necessary.
The heat pump must be installed so that maintenance work can
be carried out without hindrance. This can be ensured by main-
taining a clearance of approx. 1 m in front of and on each side
of the heat pump.
Neither frost nor temperatures higher than 35°C must occur in
the installation location at any time of the year.

6.2 Acoustic Emissions

The heat pump operates silently due to efficient sound insula-
tion. Internal insulation measures should be carried out to pre-
vent vibrations from being transmitted to the foundation or to
the heating system.
7

Installation

7.1 General Information
The following connections need to be established on the heat
pump:
Flow and return of the brine (heat source system)

 Flow and return flow of the heating system
 Temperature sensor
 Voltage supply
452235.66.22a · FD 0106
SI 6TU - SI 18TU
www.glendimplex.de