Water Hardness - Bosch HSLP451UC Manuel D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour HSLP451UC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Steam Cleaning requires 3 start/stop cycles to complete its
operation. Once started, the Steam Cleaning operation
cannot be aborted. The appliance will not operate again
until after the first and second rinse cycle to ensure that no
cleaning agent remains inside.
DESCALE: Descale the appliance at regular intervals. This
can prevent damage to the appliance. The appliance
automatically informs you when descaling is required.
Detailed instructions for descaling the steam oven are
provided in the "Cleaning and Maintenance" section of this
manual starting on page 26. The oven cannot be used for
any other purpose while descaling is in progress.
Descaling requires 3 start/stop cycles to complete its
operation. Once started, the Descaling operation cannot be
aborted. The appliance will not operate again until after the
first and second rinse cycle to ensure that no cleaning
agent remains inside.
Note:
If you use softened water, you will not need to descale the
steam oven.
WATER HARDNESS: The hardness of the tap or bottled
water (NEVER distilled water) you put in the water tank
should be determined and entered with this setting when
the appliance is installed. As explained on page 7, you may
either use water hardness strips or contact your local water
utility to find out the hardness of your tap water.
If you move or if your water source changes, you will need
to reset the water hardness value.
CALIBRATE: The boiling point depends on the air
pressure. The higher the altitude, the lower the air
pressure, and also the boiling point. The steam oven
automatically calibrates to adjust to the pressure conditions
in your area the first time steam is used at 212°F (100°C).
English 9

Publicité

Chapitres

Table des Matières

Dépannage

loading

Table des Matières