Roadstar TTR-1923UCEN Manuel D'instructions page 7

ENCODING OF PHONO INTO MP3 FILE
The system is able to ENCODE music from TURNTABLE to MP3 format and recording at
memory media with USB connecting port.
REMARK:
- The recording speed is 1:1 and according to the actual plying time of the track
- The system will creat a " AUDIO " folder and then store the encoding track in it.
- The recording format is preset at – MP3 bit rate : 128 kbps, sampling rate : 44.1khz
- No song title will be recorded during encoding mode
- To interrupt the recroding, press the " RECORD " button again during record mode.
In both media (USB/SD) inserted to the unit, until will defaulted record to USB media when
encoding from Phono.
Due to this defaulted to USB mode encode, thus, during encoding to SD card, please do
not insert the USB media, it will case the unit had abnormal pthenomenon.
A) PHONO ENCODING
1) Set the Function button to " PHONO " mode and then press the " RECORD " button (3)
directly.
2) The LCD display with show the word "
" & " " and flashing after few seconds. Now the system is starting the
encoding mode.
3) Start playback at PHONO for the track which you want to record to USB.
4) After finishing of recoding, press and hold the " RECORD " button (3) until the LCD
stops flashing and returns to " PHONO " mode.
B ) TRACK SEPARATION (BY REMOTE HANDSET)
You can divide the recorded music in single tracks during encoding from Phono to USB/SD.
Every time "TS" (Track Separation) button is pressed on the remote control during encoding
from Phono to USB/SD, the system will generate a new track and continue the recording.
"PHONO" will flash on the LCD display once to inform that the unit has successfully
created a new track.
REMOVING OF USB / MEMORY CARD
To remove the USB / MEMORY CARD, turn off the power or switch the function mode to
either AUX or TUNER first. For USB port – un-plug it by pulling out the USB socket directly,
for memory card – press the memory card inward & then release, now the card being
partially eject and you can remove it by hand.
English
USB
" and then flashing, and then display "
English
9 10
LINE OUT CONNECTION
You can connect the system to your home Hi-fi system by connecting the LINE OUT socket
(27) to the auxiliary input socket with a RCA cable (not included).
SPECIFICATIONS
Power Supply
AC:
RC Battery:
Radio Frequency Coverage
FM:
Power output
Design and specifications are subject to change without notice.
230V ~ 50Hz
2 x AAA (UM-4) 1.5V (not included)
87.5 - 108MHz
2 x 2 W RMS (10% THD)