Preflight Checklist; Daily Flight Checks - Hangar 9 F6F-5 Hellcat 15cc Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 PREFLIGHT CHECKLIST
• Charge the transmitter, receiver and motor battery for
your airplane. Use the recommended charger supplied
with your radio system. Follow the instructions
provided with the radio. Charge the radio system
the night before each fl ying session. Charge the
transmitter and receiver batteries using only included
or manufacturer-recommended chargers. Follow
all manufacturer's instructions for your electronic
components.
• Check the radio installation and make sure all control
surfaces (aileron, elevator, rudder and throttle) move
correctly (i.e., the correct direction and with the
recommended throws).
• Check all the hardware (control horns, servo horns,
and clevises) to make sure they are secure and in good
condition.
• Prior to each fl ying session (and especially with a new
model), perform a range check of your radio system.
See your radio manual for the recommended range
and instructions for your particular radio system.
• Run the motor. With the model securely anchored,
repeat the range check procedure. The range should
not be signifi cantly affected. If it is, do not attempt to
fl y! Remove the radio equipment and have it inspected
by the manufacturer.
EN
 DAILY FLIGHT CHECKS
• Check the battery voltage of the transmitter battery.
Do not fl y below the manufacturer's recommended
voltage. To do so can crash your aircraft.
When you check these batteries, ensure you have the
polarities correct on your expanded scale voltmeter.
• Check all hardware (linkages, screws, nuts, and bolts)
prior to each day's fl ight. Ensure that binding does not
occur and that all parts are properly secured.
• Ensure all surfaces are moving in the proper manner.
• Perform a ground range check before each day's fl ying
session.
• Prior to starting your aircraft, turn off your transmitter,
then turn it back on. Do this each time you start your
aircraft. If any critical switches are on without your
knowledge, the transmitter alarm will sound a warning.
• Check that all trim levers are in the proper location.
• All servo pigtails and switch harness plugs should be
secured in the receiver. Make sure the switch harness
moves freely in both directions.
 LIMITED WARRANTY
What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the original
purchaser that the product purchased (the "Product") will
be free from defects in materials and workmanship at the
date of purchase.
What is Not Covered
This warranty is not transferable and does not cover
(i) cosmetic damage, (ii) damage due to acts of God,
accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or
maintenance, (iii) modifi cation of or to any part of the
Product, (iv) attempted service by anyone other than a
Horizon Hobby authorized service center, (v) Product not
purchased from an authorized Horizon dealer, (vi) Product
not compliant with applicable technical regulations,
or (vii) use that violates any applicable laws, rules, or
regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON
MAKES NO OTHER WARRANTY OR REPRESENTATION,
AND HEREBY DISCLAIMS ANY AND ALL IMPLIED
WARRANTIES, INCLUDING, WITHOUT LIMITATION,
THE IMPLIED WARRANTIES OF NON-INFRINGEMENT,
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. THE PURCHASER ACKNOWLEDGES THAT
THEY ALONE HAVE DETERMINED THAT THE PRODUCT
WILL SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER'S INTENDED USE.
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and
exclusive remedy shall be that Horizon will, at its option,
either (i) service, or (ii) replace, any Product determined
by Horizon to be defective. Horizon reserves the right
to inspect any and all Product(s) involved in a warranty
claim. Service or replacement decisions are at the sole
discretion of Horizon. Proof of purchase is required for
all warranty claims. SERVICE OR REPLACEMENT AS
PROVIDED UNDER THIS WARRANTY IS THE PURCHASER'S
SOLE AND EXCLUSIVE REMEDY.
34
Limitation of Liability
HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT,
INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSS OF
PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY
WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED
IN CONTRACT, WARRANTY, TORT, NEGLIGENCE, STRICT
LIABILITY OR ANY OTHER THEORY OF LIABILITY, EVEN IF
HORIZON HAS BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES. Further, in no event shall the liability
of Horizon exceed the individual price of the Product on
which liability is asserted. As Horizon has no control over
use, setup, fi nal assembly, modifi cation or misuse, no
liability shall be assumed nor accepted for any resulting
damage or injury. By the act of use, setup or assembly,
the user accepts all resulting liability. If you as the
purchaser or user are not prepared to accept the liability
associated with the use of the Product, purchaser is
advised to return the Product immediately in new and
unused condition to the place of purchase.
Law
These terms are governed by Illinois law (without regard
to confl ict of law principals). This warranty gives you
specifi c legal rights, and you may also have other rights
which vary from state to state. Horizon reserves the right
to change or modify this warranty at any time without
notice.
 WARRANTY SERVICES
Questions, Assistance, and Services
Your local hobby store and/or place of purchase cannot
provide warranty support or service. Once assembly,
setup or use of the Product has been started, you must
contact your local distributor or Horizon directly. This
will enable Horizon to better answer your questions
and service you in the event that you may need any
assistance. For questions or assistance, please visit
our website at www.horizonhobby.com, submit a
Product Support Inquiry, or call the toll free telephone
number referenced in the Warranty and Service Contact
Information section to speak with a Product Support
representative.

Publicité

Table des Matières
loading

Table des Matières