Electrical Connection - Electrolux EUC 19001 W Mode D'emploi

Unscrew the adjustable feet situated
on both sides (2 pieces), in addition
the screws fixing the lower door
holders (2 pieces) and the screw on
the other side respectively.
Take off the freezer door by pulling it
slightly downwards.
Unscrew the top door hinge pin of the
refrigerator then screw it back on the
other side.
Fit the freezer door on the upper door
hinge pin.
Put over the pin in the lower door
holding plate in the direction of the
arrow.
Take the door off.
Unscrew the top door holding pin and
put it on the other side.
Put over the handles on the other side
and put the plastic covering nails
supplied in the plastic bag of this
instruction book into the holes set
free.
Put the appliance to its place, set it
level and apply voltage to it.
In case you do not want to perform the
procedures above, call the nearest
brand-mark service. Technicians will
accomplish the refitting expertly for
charge.

Electrical connection

This refrigerator is designed to
operate on a 230 V AC (~) 50 Hz
supply.
The plug must be put into a socket
with protective contact. If there is no
such, it is recommended to get an
electrician to fit an earthed socket in
compliance with standards near the
refrigerator.
This appliance complies with the
following E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage
Directive)
modifications,
- 89/336 EEC
(Electromagnetic
Directive)
modifications.
- 96/57 EEC - 96/09/03 (Energy
Efficiency Directive) and its subsequent
amendments
electrolux 55
GB
and subsequent
of 03.05.89
Compatibility
and subsequent