Stahl 8146/1 Serie Mode D'emploi page 14

Masquer les pouces Voir aussi pour 8146/1 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Product Selection, Project Engineering and Modification
US
 Modify the device carefully and only in accordance with the safety information
US
(see "Safety" chapter).
US
 Calculate the usable area for built-in components.
 Create additional drilled holes through lasing or punching (drilling, hole cutting).
US
When doing so, maintain the stipulated distances to the rim of the enclosure
US
(see figures in this chapter, "Enclosure" section and "Flange" section).
 When punching and cutting, make sure that the outer surfaces of the enclosure remain flat
US
and undamaged (without cracks).
US
 Observe the mounting distances when creating the drilled holes.
US
 Adjust the hole diameters to the dimensions of the built-in parts or their seals.
 ONLY use built-in components with flat seal (gasket).
US
 Observe chapter 5.2 when subsequently equipping components!
US
 If the technical data has changed, e.g. due to the components that are to be additionally
US
installed, attach the new rating plate with the current values.
US
US
US
US
US
US
US
US
US
US
US
US
US
US
14
Terminal Boxes
Series 8146/1, Series 8146/2
137216 / 8146626300
2021-01-08·IO00·III·en·09

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

8146/2 serie

Table des Matières