Safety Instructions - Albrecht DR 790 CD Manuel

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12. Safety instructions

Please read these instructions carefully. They contain important information which will help you get
the best from your product and ensure safe and correct installation and operation.
EN
General safety information
Keep the product and all its parts out of reach of small children.
Do not attempt to open the product. This product does not contain any user serviceable parts.
Unauthorised handling of the device may damage it and will void your warranty.
Do not use your Radio near emergency/intensive care medical equipment; if you have a pace-
maker fitted or during an electrical storm.
To avoid possible hearing damage, do not listen to this radio at high volume levels for long
periods of time. Always keep the volume within reasonable limits.
Power source
The device may only be connected to a mains voltage of 230 V ~, 50 Hz. Never try to operate
the device with a different voltage.
The mains plug may only be connected after the installation has been completed correctly.
If the mains plug is defective or if the device has other damage, it must not be put into operation.
When removing the plug from the socket, pull on the plug - not on the cable.
Always check that you have completely switched off your Radio, before disconnecting the po-
wer cord.
If the radio is not used for a long period of time, switch off the device on the back or disconnect
the power plug. This is to avoid the risk of fire.
Moisture and water
Keep it dry. Avoid exposure to precipitation, humidity and liquids which could all affect the pro-
duct circuitry.
Do not leave it in low temperatures as moisture can form inside the product, which may damage
the circuit board.
Do not use it in the dust environment as dust can damage the interior electronic components
and lead to malfunctions in the device.
Ventilation
If the radio is moved from a cold environment into a warmer one, do let it adapt to the new
temperature before operate the device. Otherwise, it might lead to condensation and cause
malfunctions in the device.
Do not block or cover slots, holes or openings on the product by placing on soft furnishings such
as carpets, rugs or beds as these are provided for functionality and/or ventilation to ensure safe
operation of the product
Heat sources and flames
Do not leave it in high temperatures as electronic devices and plastic parts may warp in heat.
Keep it away from bright sunlight or heat sources, such as a radiator.
34
English

Publicité

Table des Matières
loading

Table des Matières