Intended Use; Maintenance And Cleaning - Pontec PondoStar LED Rocklight Set 3 Notice D'emploi

- EN -

Intended use

Only use the product described in this manual as follows:
• For use in water fountain systems and ponds.
• For use above and under water.
• Operate the product in compliance with the technical data. (→ Technical data)
The following restrictions apply to the unit:
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
Installation
 A, B
WARNING
The transformer is subject to dangerous voltage and must not be installed directly adjacent to the water. Otherwise
there is a risk of severe injuries or death by electrocution.
 Install the transformer at a distance of at least 2 m from the water to ensure that it is protected against flooding.
• Position the LED spotlights and the transformer so that they do not pose a danger to anyone.
• Install the transformer so that it is protected from flooding.
– Ensure that the transformer is not placed in water.
• The LED spotlights may be installed under water.
– Max. immersion depth: 1 m
• Connect the connection cable of the LED spotlights to the transformer socket by means of the plug.
– Hand-tighten the cap nut of the plug.
Commissioning/start-up
• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.

Maintenance and cleaning

NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents can damage the housing, impair the func-
tion of the device and harm animals, plants and the environment.
 Only clean the glass of the spotlight and the transformer with a damp cloth.
 Only use clear water and a soft brush or sponge to clean the spotlight housing.
8