Brandt TI213BS1 Guide D'utilisation page 48

99625701_ML_B.qxd 19/11/04
C
hanging the type of gas supply (cont'd)
Transforming from natural gas to
butane/propane (cont'd).
A
DJUST THE RETARDER ON THE TAPS
located under the knobs. Proceed as
follows:
• Work on one tap at a time.
• Pull off all knobs.
• Using the small screwdriver provi-
ded, completely tighten the adjust-
ment screw of the brass idle jets (yel-
low) (fig. 4) anti-clockwise.
• Check the position of knobs before
putting them back in place. Make sure
the knobs are pushed down as far as
possible.
• Put the burner heads, covers and
pan supports back in position.
48
09:02 Page 48
Installing your hob in all simplicity
Tap axis Adjustment
Fig. 4
screw