Klein Tools True RMS CL600 Manuel D'instructions page 10

ENGLISH
AC VOLTAGE (LESS THAN 1000V)
1. Insert RED test lead into VΩ jack
COM jack
AC voltage V
Black lead Red lead
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
DC VOLTAGE (LESS THAN 1000V)
1. Insert RED test lead into VΩ jack
COM jack
DC voltage V
Black lead Red lead
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
NOTE: If "–" appears on the LCD, the test leads are being applied to
the circuit in reverse. Swap the position of the leads to correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of order mV may appear on the display. This is noise and
is normal. By touching the test leads together to close the circuit
the meter will measure zero volts.
10
OPERATING INSTRUCTIONS
, and rotate function selector switch
4
setting.
, and rotate function selector switch
4
setting.
, and BLACK test lead into
5
, and BLACK test lead into
5
to the
2
to the
2