Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PC Control Operation
This mode allows you to use PC software (for example: Pangolin, Phenix, Mamba) to operate. If no
ILDA signal to DB25 jack in ILDA mode, the laser and scanner will be OFF for protection. The scan
speed of software control must be less than 35K PPS, otherwise the patterns could possibly have
distortion.
1.
Use ILDA PC control to get customized laser patterns
2.
Use built-in programs setting effect mode
a.
b.
Notes
DMX console can not be used in Master/Slave operation
There should be only one Master unit in a master/slave chain.
TROUBLESHOOTING
1.
In Stand-Alone operation (Sound-Active / AUTO), if the power supply indicator is lit up, and
Sound-Active indicator isn't lit up, but the laser is OFF, please check if the unit has been set
up in slave mode. If so, set it up in Master mode
2.
In Master/Slave mode, slave unit doesn't work:
a.
b.
c.
3.
In DMX mode, the laser is OFF and the DMX signal is OFF: make sure to set up the DMX
mode
4.
In DMX mode, the unit can't be controlled by the DMX console, but the DMX signal is
flashing, please make sure the DMX console and the unit have the same channel
5.
If the unit fails, please turn off the unit, and then turn on again after 5 minutes.
After trying the above solution you still have problems, please contact your dealer
Use DMX to choose effect mode (animation effects, animation grating multi
patterns effects, 3D dot effects, 3D plane effects...)
Or Use the #5 to #8 dipswitch to set the effect mode
Make sure there is only one Master in the chain, and the others set up as slaves
Make sure to control the unit without DMX console controlling
Make sure to take a good quality power cable and connection
Publicité
Table des Matières
