Worx WG156 Instructions page 13

started from rest it will advance about .25 inches
of trimmer line.
A 'clattering' noise will be heard when the lines
hit the line cutter. DO NOT BE ALARMED this is
quit normal. After about 5 seconds the line will
be cut to the correct length and the noise will
reduce as the motor receives full speed.
If the noise of the line being cut can't be heard,
more line will need to be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely; it must come to
a complete rest, then restart, allowing the motor
to reach full speed.
Repeat above until you hear the line hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
TO MANUALLY FEED THE LINE
(See Fig. L1)
Turn off the trimmer and remove the battery
If required, line can be feed out manually.
To operate, press and release manual line feed
button (15), while gently pulling out the line until
it is long enough to reach the line cutter.
If the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool cap
and turn spool counter-clockwise until the line is
at the desired length.
TO REMOVE THE CAP (See Fig. L2)
Press and hold in the two latches (11).
Pull spool cap cover away from the spool holder
When refitting the spool cap.
Keep all areas of the cap and spool holder clean.
Replace the cap, pressing firmly down towards
the spool holder to ensure cap is fully located
into position.
Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
TO REPLACE THE TRIMMER LINE.
Turn off the trimmer and remove the battery.
Remove spool cap cover.
For your convenience it is recommended you
buy replacement spools with the trimmer line
preinstalled.
2 in 1 Grass Trimmer/Edger
TO FIT SPOOL AND LINE ASSEMBLY
(See Fig. L3)
Remove old spool from spool holder. Clear any
broken line or cutting debris from the spool area.
Pull the line from the new replacement spool
through the eyelet of the spool holder. Place
new spool into holder with cut out areas of the
spool facing inward or down. When installed into
the spool holder, the smooth side of the spool
should be visible.
Release line from cleat on the spool.
Refit the cap.
TO FIT NYLON LINE ONLY:
WARNING! Take approximately 10ft (3m)
of line. Insert 5/8"(15mm )of line into the
spool holes and wind line in the direction of the
arrows on the top of the spool.
Your Trimmer is designed to use only line with a
maximum diameter of 0.065" / 1.65mm.
IMPORTANT: Leave approximately 4" (100mm)
of line unwound and place into cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool and
line assembly".
MAINTENANCE
After use, disconnect the battery from the tool
and check for damage.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
room temperature location. Keep the motor
ventilation slots clean. Keep all working
controls free of dust.
13
EN