Operation; Fan Only; Setting Air Flow Direction - Technibel Climatisation SMDV Notice D'utilisation

OPERATION

COOLING
Place the outdoor unit outside and insert the plug in the power
socket.
Twist the knob (4) of the thermostat to the right until you
G
reach the position of maximum cooling.
Switch on the air conditioner pressing the ON/OFF push-but-
G
ton (1) , lamps of last operations are displayed.
Select the cooling operation
G
(2), lamp (5) lights.
Press the push-button (3) to select the high fan speed, the
G
lamp (6) lights.
When room temperature has reached the most suitable
G
value for your comfort, press again the push-button (3) to
select the low fan speed, the lamp (7)
Now slowly twist the thermostat knob back towards the left
G
until the compressor stops. At this point the air conditioner is
set for automatic operation under the control of the electro-
nic thermostat to maintain the room temperature at the pre-
set value.
To stop the air conditioner press again the ON/OFF push-but-
G
ton. (1).

FAN ONLY

For this operation the outdoor unit can be placed either outsi-
de(on the window sill or hanged to the wall) or inside, hanged
to the indoor unit.
The air conditioner is running in cooling mode.
Press the cooling push-button (2) to stop the compressor,
G
lamp (5) is relised (disactivated).
Select the fan speed pressing the fan speed push-button (3).
G
Starting the air conditioner in fan only mode.
Switch on the air conditioner pressing the ON/OFF push-but-
G
ton (1) .
Make sure that the lamp (5) is relised (disactivated).
G
Select the fan speed pressing the fan speed push-button (3).
G

SETTING AIR FLOW DIRECTION

To set the air flow direction, seize with both hands one of the
deflector blades and pull towards you.
pressing the push-button
lights.
6
8
7 1
5
Vertical Flow Horizontal Flow
EG
4
3
2
5