First Time Use - iStorage DISKASHUR M2 Manuel De L'utilisateur

3. First Time Use

is supplied in the 'Initial Shipment State' with no pre-set Admin PIN. A 7-15 digit Admin PIN must be
diskAshur M
2
configured before the drive can be used. Once an Admin PIN has been successfully configured, it will then not be possible to switch the
drive back to the 'Initial Shipment State'.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Password Tip: You can configure a memorable word, name, phrase or any other Alphanumerical PIN combination
by simply pressing the button with the corresponding letters on it.
Examples of these types of Alphanumerical PINs are:
• For "Password" press the following buttons:
7 (pqrs) 2 (abc) 7 (pqrs) 7 (pqrs) 9 (wxyz) 6 (mno) 7 (pqrs) 3 (def)
• For "iStorage" press the following buttons:
4 (ghi) 7 (pqrs) 8 (tuv) 6 (mno) 7 (pqrs) 2 (abc) 4 (ghi) 3 (def)
Using this method, long and easy to remember PINs can be configured.
To configure an Admin PIN and unlock the diskAshur M
Instructions - First Time Use
1. Connect the diskAshur M
2
computer
2. Press and hold down both KEY ( ) + 1 buttons
3. Enter a New Admin PIN (7-15 digits) and press the
KEY ( ) button once
4. Re-enter your New Admin PIN and press the KEY ( )
button again
Locking the diskAshur M
2
To lock the drive, safely eject the diskAshur M
written to the drive, unplugging the diskAshur M
for the first time, please follow the simple steps in the table below.
2
to a powered USB port on your
from your host operating system and then unplug from the USB port. If data is being
2
will result in incomplete data transfer and possible data corruption.
2
www.istorage-uk.com
LED LED State
RED, GREEN and
sequence then the
switches to solid
drive is in the Initial Shipment State
LEDs turn to blinking
Blinking GREEN
GREEN blink then back to Blinking
BLUE LEDs
BLUE LED rapidly blinks then switches to a solid
LED and finally to a solid
Admin PIN has been successfully configured and drive
unlocked
BLUE LEDs blink once in
GREEN LED blinks twice and finally
RED and GREEN LEDs indicating the
GREEN and solid BLUE
and solid BLUE LEDs switch to a
GREEN and solid
GREEN LED indicating the
BLUE
#7