Possible Defects - Bartscher Panini 1RDIG Mode D'emploi

Masquer les pouces Voir aussi pour Panini 1RDIG:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
7.

Possible defects

In case of malfunction immediately disconnect the device from the power supply
(unplug). Before contacting the customer service department or vendor check the
troubleshooting table below.
Problem
The grill plates do not get
warm although the device
has been turned on and
the orange temperature
indicator light is on.
The device is switched on.
The orange indicator light
is on but the temperature
cannot be set.
The orange heating up
indicator light is not on
although the device is
turned on and the grilling
process runs as normal.
The green indicator light in
the ON/OFF switch is not
on although the device is
turned on.
If the malfunction cannot be fixed:
NOTE
Improper use may cause damage.
Never open the body.
Notify the vendor or customer service. Indicate the type of the fault and the item code
number, and serial number of the device. This information is located on the rating plate
in the rear face of the device.
Possible reason
The temperature
controller knob is
damaged.
At least one heating wire
is damaged.
The overheating
protection has been
activated.
The temperature
controller is damaged.
The indicator light is
damaged.
Incorrect or missing
power supply.
The fuse is activated.
Solution
Contact the vendor.
Contact the vendor.
Leave the device to cool
down and push the
RESET button located at
the lower part of the
.
device
Contact the vendor.
Contact the vendor.
Check the power supply
and the cable for damage
or faults.
Contact the vendor.
- 35 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

A150684

Table des Matières