Cardin Elettronica YPR8511CC Instructions D'utilisation page 9

PROGRAMMING PROCEDURE (Setting the programmer, deceleration times and the current sensor)
Attention! Before starting the barrier must be completely closed. Press the "SEL" button to move the barriere to the completely closed position.
• Make sure that display "D" is off and LEDs "L4", "L5", "L7", "L8" are all lit. LED "L6" off means the closing travel limit is activated
(if it has been installed)
• Open the "Standard wiring diagram" which is folded inside the last page of this manual and carry out the programming procedure.
D
PRESS THE PROG BUTTON FOR MORE
THAN 4 SECONDS: THE PARAMETER
DEFINITION LETTER "d" WILL APPEAR
ON THE DISPLAY (STAGE "A")
AFTER  SECOND THE DIGIT "" WILL APPEAR
(FIRST PROGRAMMING STEP). THIS NUMBER CAN BE
EITHER FLASHING OR FIXED
ACTIVE
FUNCTION
PRESS
Dynamic button
PROG
open-close
Note 
PRESS SEL
Automatic
PRESS
reclosing
PROG
enabled
PRESS SEL
Preflashing PRESS
PROG
enabled
PRESS SEL
Travel limits
PRESS
enabled
PROG
PRESS SEL
Warning light
output
PRESS
fixed PROG
PRESS SEL
Deceleration
PRESS
anabled
PROG
PRESS SEL
Non flashing
PRESS
indicator light
PROG
PRESS SEL
FTC_I active
PRESS
even when
PROG
stopped
Note 4
PRESS SEL
PRESS
SEL
WAIT FOR ABOUT 20 SECONDS WITHOUT PRESSING ANY
BUTTONS: THE PROGRAMMER WILL SAVE THE PARAMETERS
SET UP TO NOW AND WILL QUIT PROGRAMMING.
...4... sec.
Important notes regarding the programmer settings
Note  Travel direction inversion only during the closing stage.
Note 2 The travel limits must never be disabled when at least one is installed.
Note 3 The indicator light flashes slowly during opening, quickly during closing;
... sec.
Note 4 If the photoelectric cells are in alarm and the barrier is blocked no movement
ACTIVE
FUNCTION
Dynamic button
open-block
close-block
Automatic
reclosing
excluded
Preflashing
excluded
Travel limits
excluded
Note 2
Warning light
output
intermittent
Deceleration
excluded
Non flashing
indicator light
Note 3
FTC_I active
only when
closing
PRESS
PROG
...20... sec.
remains lit when the gate/door is not completely closed and is off when the
gate/door is completely closed.
commands will be accepted (not even in the opening direction).
PRESSING THE "PROG" BUTTON WILL MOVE YOU TO
STAGE "B" . PROGRAMMING THE DECELERATION TIME.
THE VALUES CAN BE CHOSEN FROM 2 TO 4 SECONDS.
ALTERNATING
ALTERNATING
PRESS
SEL
ALTERNATING
ALTERNATING
PRESS
SEL
ALTERNATING
ALTERNATING
PRESS
SEL
PRESS
PROG
WAIT FOR ABOUT 20 SECONDS WITHOUT PRESSING
ANY BUTTONS: THE PROGRAMMER WILL SAVE THE
PARAMETERS SET UP TO NOW AND WILL QUIT
PROGRAMMING.
9
FIXED
VALUE
SELECTION
PRESS
2 SECONDS
PROG
FIXED
VALUE
SELECTION
PRESS
3 SECONDS
PROG
FIXED
VALUE
SELECTION
PRESS
4 SECONDS
PROG
PREMERE
SEL
...20... sec.
CONTINUE ON PAGE 0