DAITEM DP8000 Mode D'emploi page 22

P r e s e n t a t i o n
Command receivers provide the following
applications:
G the control of a light or a strobe in order
to deter an intruder and to allow localisa-
tion of an alarm.
G the control of automatic devices via a a
remote control, a keypad, a command by
telephone...
Configured at the time of installation to
react in case of alarm (Intrusion alarm,
Technical 1, Alert or Tamper), or to react to
transmissions from a remote control or a
keypad (Arm, Off, Light, Gate, Electric lock...),
offering 4 operating modes:
1 - remote control unit mode (change of
state of relay at each command),
2 - On/Off mode (activation of the relay by
one command, deactivation by another),
GB
3 - timer mode (activation of the relay for
3 mins or 30 mins),
4 - momentary mode (relay impulse of
2 secs at each command).
An LED in the cover indicates the state of
the relay (green at rest, red at work).
22
The output contact of the receiver is a
standard dry contact (48 V/1 A).
It is compatible with all products of the
D14000 system and the DP8000 system
(with the exception of remote controls
D8601, D8602, D8603 and D8604).
P r e p a r a t i o n
Powering
G The power supply is 230 V (50 Hz) pro-
tected (protection module 230 V/5 A bipo-
lar).
G Use cables with a maximum section of
2.5mm 2 .
Daitem