the board.
Solder the wires to the pads, holding the
TCXO module firmly tight against the 28-pin
IC socket.
Note that when using the TCXO module, the reference frequency setting must be
25,000,000 MHz, not the default which is 27,004,000 MHz. This is further described in
the initial set-up instructions, below.This is because the QCX-mini can operate either
with 25MHz reference (the TCXO module) or with 27MHz (the supplied crystal), BUT,
you have to tell it which one you have installed!
3.15 Install 500-ohm multi-turn trimmer potentiometer
This 24-turn trimmer resistor is the small blue box component with label "501". It is R27.
The trimmer resistor has to be prepared carefully before installation. The resistor has little
ledges on either side which make it slightly too high to fit in the QCX-mini PCB assembly.
Therefore simply cut off these protrusions with a wire-cutter.
Note the ledges
towards the 28-pin IC socket as possible.
Cut off excess wire; be careful because the
TCXO board is single sided without through-
hole plating, so the pads are a bit delicate.
Cut ledge off with wire-cutter
QCX-mini assembly Rev 1.05_Fr
Enjoy less high trimmer pot!
47