Disassembly Of Guides And Side Catalytic Shields; Cleaning Of The Chamber Interior - Fagor CFF 964E Notice D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
CAUTION!
1. The hinge bow is tense with a big strength, therefore while taking out the
door a special care must be taken not to cut one's own fingers.
2. During cleaning the upper wall of oven you should pay attention to electric
heaters, temperature sensor and lamp of oven illumination; do not change
position of sensor setting.
3. Do not pour water onto the bottom of oven otherwise it may trickle through
some possible leakage and get on the lower heater.

5.4.2 DISASSEMBLY OF GUIDES AND SIDE CATALYTIC SHIELDS

1
In order to replace the side catalytic shields, first disassemble both sets of the guides.
Removing the guides:
− − − − −
press down the top bar of guides 1 in order to release catch 2 from hole 3,
tilt guides 1 toward the inside of the oven and release the lower bars from holes 4,
put catalytic shields 5 aside,
steep the guides in a solution of warm water and detergent, and then brush them
with the use of a sponge or soft brush.
Clean the ladder guides with a sponge or brush using dish washing agent. After cleaning,
take all actions in the reverse sequence to disassembly.

5.4.3 CLEANING OF THE CHAMBER INTERIOR

After removing all catalytic shields you can clean the inside of the chamber
Clean the enamelled surfaces with agents intended for cleaning the kitchen.
In order to clean stubborn baked stains you can use a special cleanser intended for
oven cleaning. As these detergents are caustic, you should use them in minimal
amount and with a great caution, observing the recommendations of detergent
manufacturer.
"
In order to make cleaning of the oven interior easier, you can switch on the lamp. In
order to do it, set the function selection knob to any function and the temperature
control knob in "0" position. The lamp will remain lit.
"
In order to clean glass cover of the lamp (item 1 in fig. 13), unscrew it, wash in warm
water and deter-gent, dry and refit.
CLEANING AND MAINTENANCE
5
3
2
4
4
14
Fig. 12

Publicité

Chapitres

Table des Matières
loading

Table des Matières