Installation; Positioning; Electrical Connections - Fagor CFF 964E Notice D'installation Et D'utilisation

2 INSTALLATION

2.1 POSITIONING

• Remove all packaging components off the cooker, including protective coatings
applied to chromium-plated surfaces and stainless steel components.

2.2 ELECTRICAL CONNECTIONS

Cooker shall be properly connected to mains by qualified electrician according to
safety regulations in force. No modifications or changes to electric system of the
cooker are allowed.
Before starting with connecting the unit, make sure for:
- rated voltage of the mains is identical to that specified in the data plate of the
cooker;
- feeding line for the cooker is sufficient for the maximum power consumed by the
appliance as specified in its data plate.
Electric mains feeding the cooker shall be provided with safety switch allowing
disconnecting power in emergency. Working contacts of the safety switch shall be spaced
each other to at least 3 mm.
When connecting the supply cable to the mains bear in mind the following:
- yellow-green wire shall be connected to earth terminal identified
- blue wire is the neutral,
- brown, black and red wires shall be connected to live terminals,
- any lead must never touch hot surfaces over 75
- if the cooker comes without mains cable, use cable type H05RR-F or H05V2V2
sized as specified below.
GENERAL INFORMATION
• Kitchen room shall be dry and well ventilated.
Cooker shall be positioned so as to ensure free
access to all its controls.
• By placing the cooker in series with kitchen
furniture the distance between its cooker lateral
walls and the cupboards cannot be less than
20mm.
• The distance between the heating plate and
kitchen hood shall be at least 650 mm.
• Level the cooker before using it. To do this, use
adjustable feet accessible when you remove
the drawer.
Fig. 2
5
0 C,
GB
,